Albion Strut System
Side Rail Supports / Eaves Struts
Side rail supports are manufactured from pre-hot dipped galvanised mild steel and cold roll formed into an angle section 45 x 45 x 2.0mm thick.
Only side rail supports fabricated as shown will give the necessary stability under wind pressure or suction loads.
Standard Gauge Line Detail
| Section Ref | Standard Gauge Line Centres mm* | Dim F mm |
| 125 | 60 | 110 |
| 146 | 65 | 115 |
| 175 | 95 | 145 |
| 207 | 115 | 165 |
| 227 | 115 | 165 |
| 247 | 150 | 200 |
| 265 | 165 | 215 |
| 307 | 200 | 250 |
| 341 | 245 | 295 |
| 401 | 300 | 350 |
Note: When side rail supports are used in conjunction with diagonal tie wires at a mid point location (see page 22 of online brochure) the actual overall length will be rail centres less 7mm. For side rail supports used at intermediate and third point location (see page 23 of online brochure) the actual overall length will be rail centres less thickness of rail.
End Cleat Types
Standard Cleat
|
|
End Cleat turned through 90.
|
Note: All holes in the side rail support strut are 14mm diameter except when the strut is attaching to a C section via a countersunk bolt (see page 26 of online brochure). At this position only the hole should be 18mm diameter to suit the 16mm diameter countersunk bolt.
Home > Products
